Dear James: I have noticed the paint job on the exterior of my house looks terrible in some spots. My house has lap siding which we installed ourselves. There is blistering in certain spots that makes the house look really bad. What is causing this and how do I fix it? — Robin R.
Dear Robin: No one wants the outside of their house to be an eyesore, but this problem may be more involved than it looks. Blistering and peeling can lead to wood decay and loss of insulation value. What is likely causing the blistering is moisture that gets trapped in the wood and is drawn to the surface by the sun’s rays. This can happen for a number of reasons including humidity, construction defects or lack of effective vapor barriers.
Blistering is often more prevalent around the kitchen and bathroom areas. Water vapor from cooking, dishwashing, laundry, bathing and normal activities of a family of four contributes about three gallons of water per day to the humidity. So if you don’t have a vapor barrier, or if it was installed improperly, this could be the major factor causing the blistering. Water vapor gets into the walls during cold weather and condenses. Eventually, this water soaks into the siding and wets the paint causing blistering and peeling.
The moisture could also be coming from leaky plumbing, overflowing sinks, bathtubs or shower spray, or improperly sealed walls. Also look for a leak in the gutters or eaves of your house. Leaky gutters also cause damage to the foundation and interior walls of houses.
After looking for leaks you should install siding vents. These fans allow moisture from inside the house to evaporate before penetrating the wood. Getting rid of the water source is a very important step to fixing blistered paint.
After you have found and solved the source of the problem, you need to fix the existing paint job. Sand and peel off the old paint in the blistered area all the way down to the fresh wood. Scrape the unblistered paint out approximately 12 inches away from the blistered area.
Prime the exposed areas with a good grade of undercoat paint. If there is a very large area of paint that has blistered use a pressure washer or a heat gun to speed up the removal process.
Be sure you thoroughly wash the surfaces before painting. Some paint manufacturers recommend using powdered commercial cleansers; however, be careful using them. Some cleansers can be very harsh on your eyes and skin.
Wash the areas with a sponge or brush and rinse thoroughly then let the area dry before you apply the primer and paint. It is very important to allow enough drying time before you apply the primer.
To prevent possible future problems, seal any cracks, holes or seams with a caulking compound. Once the caulk and undercoat have dried thoroughly apply a coat of outside house paint.
By now your house should be looking good again and you just might have saved yourself from future headaches over a damaged foundation or decayed wood.
Send your questions to Here’s How, 6906 Royalgreen Dr., Cincinnati, OH 45244 or visit www.dulley.com.